REBEL 3D

kroxigor píše:A další blbost co vidím jako chybu když se tiskne víc objektů, že při přechodu na další vrstvu začne tisknout novou vrstvu na objektu kde tisknul jako poslední tedy na nejméně vychladlou. Logicky by měl přejet na vychladlou část.

Print islands sequentially without optimization function píše:The print islands sequentially without optimization option changes the order in which the slicer prints "islands", or isolated areas of a particular layer. Usually, it will print all the islands of a layer in order, then do the next layer in reverse order so that time isn't wasted in traveling back to the original first island to start over. This is good for reducing print times, but for small objects where each layer doesn't take a long time, it is bad for cooling. The hot extruder warms the plastic near it, and laying down new plastic on top of warm plastic leads to deformation. The islands near the start and end of the sequence get a double dose of heat because they get two consecutive layers at a time. Printing them sequentially (i.e., in the same order every time) gives every island the same amount of time to cool between layers.